Mechanical Operations Quiz 3

Flow of filtrate through the cake in a plate and frame filter press is best described by the _______ equation?

Filtration capacity of a rotary drum vacuum filter depends upon the________?

Fick?s law relates to__________?

Filtrate flow rate in case of a rotary drum vacuum filter (in which Rm < < Rc) is proportional to _____ and the cycle time (where, ? = filtrate viscosity Rm = filter medium resistance Rc = cake resistance)?

Filtration rate does not depend upon the_________?

Filtration of water in a paper mill is done by a/an ________ filter?

For efficient grinding, ball mills must be operated___________?

For benefication of iron ore, the most commonly used method is_______?

For raschig rings, the sphericity is_______?

Gyratory crushers compared to the reciprocating jaw crushers___________?

For transporting pasty material, one will use a/an___________?

For a cyclone of diameter 0.2 m with a tangential velocity of 15 m/s at the wall, the separation factor is___________?

For spheres, the surface shape factor is given by (where, A = area, V = volume, and D = diameter) ?

For classification of potable (drinking) water, we use a ________ filter?

Fluid energy mill comes in the category of_________?

Fibrous material is broken by a___________?

Np ? 1/NRe choiceno C Short distance transportation of grain, gravel, sand, ash, asphalt etc. is done by using a _______ conveyor?

For coarse reduction of hard solids, use ______?

Grinding characteristic of a material is given by its_____?

Grizzlies are used for separating ______ solids?

Grindability of a material does not depend upon its_______?

For a sphere falling in the constant drag co-efficient regime, its terminal velocity depends on its diameter D. as__________?

For a non-spherical particle, the sphericity___________?

For spheres, the specific surface shape factor is given by_____?

Grinding efficiency of a ball mill is of the order of ________ percent?

For the transportation of ultrafine particles, the equipment used is a _____ conveyor?

For separation of sugar solution from settled out mud, we use a _____ filter?

For the preliminary breaking of hard rock, we use a______?

Filtration operation carried out by continuous increase of the inlet pressure of slurry, is called the ______ filtration?

Gelatinous solid (which plug the septum) can be filtered by a ______ filter?

Gravity settling process is not involved in the working of a_________?

Filter medium resistance is important during the _______ of filtration?

For Indian standard (IS) screens, the mesh number is equal to its aperture size expressed to the nearest deca-micron (0.01 mm). Aperture width of IS screen of mesh number 50 will be approximately ______ microns?

General crushing equation is given by d(P/m) = -K (dD? S/D? n S). Bond?s crushing law is obtained by solving this equation for n = ______ and feed of infinite size?

Fluid medium used in the classification technique of mineral beneficiation is__________?

For spheres, volume shape factor is given by______?

Gold ore concentration is mostly done using_____?

Filtration should be stopped in a filter press, if the__________?

Gravity stamp mill is meant for the _____ crushing?

For achieving maximum capacity of the ball mill, the ball charge should be equal to about _______ percent of the ball mill volume?

Filter aid is used to______?

Froth floatation is the most suitable for treating ______?

Filtration rate through a filter cake is proportional to (where, S = filtering surface R = specific cake resistance ? = viscosity of the filtrate) ?

For removal of very small amounts of precipitate from large volume of water, the most suitable filter is the _______ filter?

For laminar flow of filtrate through the cake deposited on septum, which of the following will be valid ?

Filter medium resistance is that offered by the___________?

For sizing of fine materials, the most suitable equipment is a______?

Float and sink test determines the possibility of cleaning of coal by a process based on the_____?

General mechanism of size reduction in intermediate and fine grinder is by ___________?

For crushing of solids, the Rittinger?s law states that the work required for crushing is proportional to ___________?