Electrical Engineering Quiz 69
1 / 50
Which of the following is expected to have the maximum permeability ?
2 / 50
In a synchronous motor running with fixed excitation, when the load is increased three times, its torque angle becomes approximately
3 / 50
In a pnp transistor, the current carriers are______________?
4 / 50
There are ______________ h parameters of a transistor?
5 / 50
The frame of an induction motor is usually made of____________?
6 / 50
Open circuited armature coil of a D.C. machine is________________?
7 / 50
Which of the following is an essential part of a motor meter ?
8 / 50
A 30 V Zener will have depletion layer width_______________ that of 10 V Zener?
9 / 50
The unit of capacitance is__________?
10 / 50
According to application, instruments are classified as_____________?
11 / 50
In an actual transformer the iron loss remains practically constant from no load to full load because:____________?
12 / 50
Which of the following should be done to make an unstable system stable ?
13 / 50
In a charged capacitor the energy resides in________________?
14 / 50
Power for lighting in passanger coach, in a long distance electric train, is provided_________________?
15 / 50
A trivalent impurity has______________valence electrons?
16 / 50
In the above circuit the current ix is___________?
17 / 50
An amplifier using an opamp with slew rate SR=1v/sec has a gain of 40db.If this amplifier has to faithfully amplify sinusoidal signals from dc to 20KHz without introducing any slew-rate induced distortion, then the input signal level exceed_____________?
18 / 50
Lagging of changes in the magnetization of a substance behind changes in the magnetic field as the magnetic field is varied is known as magnetic_____________?
19 / 50
The injected e.m.f. in the rotor of induction motor must have__________?
20 / 50
Lead-acid cell has a life of nearly charges and discharges______________?
21 / 50
The underground system cannot be operated above_________________?
22 / 50
Pure inductive circuit takes power from the A.C. line when_________?
23 / 50
Hard steel is suitable for making permanent magnets because_____________?
24 / 50
The direction of rotation of an hysteresis motor is determined by____________?
25 / 50
In the above question, what is the power in sidebands ?
26 / 50
For handling greater currents induction wattmeters are used in conjunction with______________?
27 / 50
In all base driver amplifiers__________?
28 / 50
A string of n parallel SCRs is operated at 72 KA, the rating of each SCR is 1 K If derating factor of the string is 0.1. value of n will be___________?
29 / 50
Disc windings are primarily used in_____________-?
30 / 50
For transmission of power over a distance of 500 km, the transmission voltage should be in the range?
31 / 50
The leakage flux in a transformer depends upon______________?
32 / 50
A synchronous motor can be started by________?
33 / 50
The most popular form of IC package is _____________?
34 / 50
Internal resistance of a cell is reduced by__________?
35 / 50
When current feedback (negative) is applied to an amplifier, its output impedance ________________?
36 / 50
An SCR is turned off by _________________?
37 / 50
A semiconductor has generally_______________valence electrons?
38 / 50
____________is a part of the human temperature control system?
39 / 50
Negative feedback is employed in __________________?
40 / 50
It is desirable to operate the arc furnaces at power factor of_____________?
41 / 50
A controller, essentially, is a________________?
42 / 50
In parallel resonance, there is _______________?
43 / 50
The apparent power drawn by an A.C. circuit is 10 kVA and active power is 8 kW. The reactive power in the circuit is_________?
44 / 50
Overhead lines for power supply to tramcars are at a minimum height of______________?
45 / 50
The forbidden gap in an insulator is________________?
46 / 50
The vafcie of transformation ratio of an induction motor can be found by__________?
47 / 50
The ripple factor of a half-wave rectifier is_________________?
48 / 50
Following power plant has instant starting?
49 / 50
The insulation on a current carrying conductor is provided__________?
50 / 50
The amount of air which is supplied for complete combustion is called___________?
Provide Your Information
Your score is
The average score is 88%
Restart quiz
