Electrical Engineering Quiz 51
1 / 50
Self-inductance of a long solenoid is______________?
2 / 50
The pressure at the furnace is minimum in case of___________?
3 / 50
__________ has a low relative permeability and is used principally in field frames when cost is of primary importance and extra weight is not objectionable?
4 / 50
In a D.C. generator in case the resistance of the field winding is increased, then output voltage will____________?
5 / 50
Emitter follower is used for________________?
6 / 50
The increased load during summer months is due to____________?
7 / 50
A capacitive load in voltage source inverters generates ________________?
8 / 50
The sum of all phase current in a star connected primary winding with no neutral connection is equal to___________?
9 / 50
The resistance of a few meters of wire conductor in closed electrical circuit is____________?
10 / 50
Mostly, synchronous motors are of_____________?
11 / 50
If the current in a capacitor leads the voltage by 80?, the loss angle of the capacitor is_________________?
12 / 50
A circuit is disconnected by isolators when____________?
13 / 50
The stability factor of a collector feedback bias circuit is_______________ that of base resistor bias?
14 / 50
The use of negative feedback ________________?
15 / 50
An isolator is installed_____________?
16 / 50
Synchronsizing power of a synchronous machine is_____________?
17 / 50
A.C. series motor as compared to D.C. series motor has__________?
18 / 50
The speed characteristics of an induction motor closely resemble the speedload characteristics of which of the following machines?
19 / 50
Rankine cycle operating on low pressure limit of p1 an 1 high pressure limit of p2__________?
20 / 50
________________is preferred for automatic drives?
21 / 50
The material used for fuse must have_____________?
22 / 50
A hysteresis motor works on the principle of__________?
23 / 50
The distributors for residential areas are______________?
24 / 50
In induction motors, the length of air gap in kept as small as mechanically possible is order to have____________?
25 / 50
The fan put of a 7400 NAND gate is_______________?
26 / 50
The dielectric constant (relative permittivity) of glass is given by___________?
27 / 50
In a control system the output of the controller is given to_____________?
28 / 50
Rotor of a motor is usually supported on ___________________ bearings?
29 / 50
The impurity atoms is semiconductors_____________?
30 / 50
If a wire conductor of 0.2 ohm resistance is doubled in length, its resistance becomes______________?
31 / 50
In a CB amplifier the maximum efficiency could be____________?
32 / 50
The output characteristics of a JFET closely resemble the output characteristics of a ___________ valve?
33 / 50
Kirchhoff s law is applicable to____________?
34 / 50
Ground resistance should be designed such that_____________?
35 / 50
The voltage gain of a transistor connected in common collector arrangement is____________?
36 / 50
For measurement of inductance having high value, we should use______________?
37 / 50
The time constant and R-C circuit may also be defined as the time during which the charging current falls to ________ percent of its initial maximum value
38 / 50
The converse of hardness is known as______________?
39 / 50
The following resistors are in parallel across a voltage source: 220? , 470? , and 560? . The resistor with the least current is______________?
40 / 50
A perfect black body is one that_____________?
41 / 50
Which of the following material is not a semiconductor ?
42 / 50
Hysteresis loss in a transformer varies as CBmax = maximum flux density) ?
43 / 50
If the load on a DC shunt motor is increases, its speed is slightly reduced due to______________?
44 / 50
Ward-Leonard control is basically a____________?
45 / 50
In a 3 phase VSI SPWM to use a single carrier signal and preserve the features of PWM technique, the normalized carrier frequency should be____________?
46 / 50
A carrier based PWM technique in CSI is composed of____________?
47 / 50
A crowbar is a circuit which is used to protect a_____________?
48 / 50
In any rotating machine that part which houses the conductors and in which e.m.f. induced is to be utilized is called____________?
49 / 50
The bedding on a cable consists of____________?
50 / 50
A certain voltage divider consists of two 12 k? resistors in series. Which of the following load resistors will have the most effect on the output voltage?
Provide Your Information
Your score is
The average score is 91%
Restart quiz
