Electrical Engineering Quiz 53
1 / 50
When the load is above _______________ a synchronous motor is found to be more economical?
2 / 50
If firing angle in an SCR circuit is increased, the output _____________?
3 / 50
What is/are the configurable functions of each and every IOBs connected around the FPGA device from the operational point of view ?
4 / 50
is the property of absorbing moisture from atmosphere_____________?
5 / 50
A nuclear power plant is invariably used as a__________?
6 / 50
Which of the following has the highest value of thermal conductivity ?
7 / 50
In a lead-acid battery the energy is stored in the form of___________?
8 / 50
Heat control switches are used in__________________?
9 / 50
capacitors can be used only for D.C ?
10 / 50
Evaporative type of condenser has___________?
11 / 50
The property of a conductor due to which it passes current is called___________?
12 / 50
Which of the following statements regarding hysteresis motor is in incorrect?
13 / 50
Which of the following cell has a. reversible chemical reaction ___________?
14 / 50
In a full wave rectifier, the rectification ratio is approximately equal to____________?
15 / 50
The number of armature parallel paths in a two-pole D.C. generator having duplex lap winding is______________?
16 / 50
A synchronous motor develops maximum power when load angle is____________?
17 / 50
Zero initial condition for a system means_______________?
18 / 50
If a square wave is fed to a differentiating circuit, the output will be _____________?
19 / 50
The square waveform of current has following relation between r.m.s. value and average value?
20 / 50
Negative feedback in an amplifier____________?
21 / 50
Which of the following are not repayable after a stipulated period?
22 / 50
A small coil lies inside a large coil. The two coils are horizontal concentric and carry currents in opposite directions. The large coil will experience______________?
23 / 50
Hysteresis loss least depends on____________?
24 / 50
The point of intersection of d.c. and a.c. load lines represents __________________?
25 / 50
A no-load test is performed on a transformer to determine_______________?
26 / 50
SF6 gas______________?
27 / 50
In a certain common-source D-MOSFET amplifier, Vds =3.2 V r.m. and Vgs = 280 mV r.m.s. The voltage gain is_______________?
28 / 50
Electric pressure is also called________?
29 / 50
Resistances can be measured with the help of_______________?
30 / 50
The material commonly used for sheaths of underground cables is______________?
31 / 50
In a capacitor start single-phase motor, when capacitor is replaced by a resistance____________?
32 / 50
For starting a D.C. motor a starter is required because___________?
33 / 50
A 741-Type OP-AMP has a gain-bandwith product of 1MHz. A non-inverting amplifier using this opamp & having a voltage gain of 20db will exhibit -3db bandwidth of______________?
34 / 50
The disadvantage of base resistor method of transistor biasing is that it_________________?
35 / 50
Electric force between two point charges in air or vacuum is F. If we replace air or vacuum by an insulator (dielectric) of relative permitivity Cr the force between the charges will_______________?
36 / 50
When the crystal current diode current is large, the bias is ______________?
37 / 50
Which of the following motors is preferred for tape-recorders ?
38 / 50
Under over voltage condition impedance offered by the voltage clamping device is__________?
39 / 50
At transition temperature the value of critical field is____________?
40 / 50
The function of conservator in a transformer is___________________?
41 / 50
Thermal voltage VT can be given by____________?
42 / 50
When two ends of a circular uniform wire are joined to the terminals of a battery, the field at the center of the circle?
43 / 50
The superposition theorem requires as many circuits to be solved as there are____________?
44 / 50
In D.C. machines the number of slots per pole usually lies___________?
45 / 50
A star circuit has element of resistance R/2. The equivalent delta elements will be_____________?
46 / 50
A zener diode is________________ device?
47 / 50
The selection of an electric motor for any application depends on which of the following factors ?
48 / 50
____________are used for construction of core of electromagnets?
49 / 50
Insulating materials have the function of______________?
50 / 50
When a 1.6 k? resistor and a 120? resistor are connected in parallel, the total resistance is____________?
Provide Your Information
Your score is
The average score is 97%
Restart quiz
