Electrical Engineering Quiz 49
1 / 50
The material for armouring on cable is usually__________?
2 / 50
Series capacitors are used to_________________?
3 / 50
The power MOSFET device is a___________?
4 / 50
In a steam locomotive electric power is provided through_____________?
5 / 50
If the temperature increases, the value of VCE_________________?
6 / 50
The formula __________ determines the number of electrons that can be accommodated in any level?
7 / 50
At series or parallel resonance, the circuit power factor is ________________?
8 / 50
The cooling section in the surface condenser__________?
9 / 50
Internal resistance of ideal current source is ?
10 / 50
Iron losses in a D.C. machine are independent of variations in_____________?
11 / 50
The input control parameter of a JFET is __________________?
12 / 50
The angular displacement between two interconnected stations is mainly due to___________?
13 / 50
The insulating material should have____________?
14 / 50
Which of the following protects a cable against mechanical injury___________?
15 / 50
Which of the following could be lamina-proximately the thickness of laminations of a D.C. machine ?
16 / 50
Which triggering is the most reliable____________?
17 / 50
Power factor of the system is kept high__________?
18 / 50
If a 3-phase supply is given to the stator and rotor is short circuited rotor will move___________?
19 / 50
The final stage of a multistage amplifier uses______________?
20 / 50
Which of the following motors is used in a situation where load increases with speed ?
21 / 50
An ammeter has a resistance of G ohms and range of I amperes. The value of resistance required in parallel to convert it into an ammeter of range nI is______________?
22 / 50
In the common mode, _______________?
23 / 50
At room temperature, an intrinsic semiconductor has_______________?
24 / 50
A three point starter is considered suitable for______________?
25 / 50
In which of the following appUcations, direct current is absolutely essential ?
26 / 50
A differential amplifier is invariably used in the i/p stage of all op-amps. This is done basically to provide the op-amps with a very high______________?
27 / 50
Battery container should be acid resistance, therefore it is made up of___________?
28 / 50
In an LC oscillator, if the value of L is increased four times, the frequency of oscillations is __________?
29 / 50
With conventional hydrogen cooling it is possible to increase the rating of a single unit to___________?
30 / 50
Which following is a two terminal three layer device?
31 / 50
An amplifier has a power gain of 100. Its db gain is ________________?
32 / 50
Which of the following component, in a steam power plant, needs maximum maintenance attention?
33 / 50
Voltage dependent resistors are used_____________?
34 / 50
In phase-shift control method the control is carried out by varying the of grid voltage
35 / 50
Which of the following motor will have relatively higher power factor ?
36 / 50
Vacuum is created by which of the following ?
37 / 50
For germanium transistor amplifier, VCE should_______________for faithful amplification?
38 / 50
Multi-layer helical windings are commonly used in the transformers as high voltage windings_______________?
39 / 50
For 25 kV single phase system power supply frequency is_______________?
40 / 50
The value of collector load RC in a transistor amplifier is _______________the output impedance of the transistor?
41 / 50
D.C. motor is to a drive a load which is almost nil for certain part of the load cycle and peak value for short duration. We will select this______________?
42 / 50
The bar magnet has____________?
43 / 50
The absolute permittivity of free space is given by_____________?
44 / 50
Which of the following is the major consideration to evolve a good design?
45 / 50
When the field of a synchronous motor is under-excited, the power factor will be____________?
46 / 50
When a magnet is in motion relative to a coil the induced e.m.f. does not depend upon____________?
47 / 50
Which of the following D.C. distribution system is the simplest and lowest in first cost ?
48 / 50
Lenz?s law is a consequence of the law of conservation of__________?
49 / 50
Which of the following single-phase induction motors is generally used in time phonographs ?
50 / 50
Following energized winding of a D.C. machine should not be opened as it would produce high inductive voltage which may be dangerous to personnel and may cause its own insulation failure.
Provide Your Information
Your score is
The average score is 90%
Restart quiz
