Civil Engineering Quiz 30
1 / 50
The expected out turn for earth work in excavation in ordinary soil per workman per day is______?
2 / 50
The maximum slenderness ratio of a compression member carrying both dead and superimposed load is__________?
3 / 50
A cable loaded with 10 kN/m of span is stretched between supports in the same horizontal line 100 m apart. If the central dip is 10 m, then the maximum and minimum pull in the cable respectively are___________?
4 / 50
For a body floating in a liquid the normal pressure exerted by the liquid acts at ________?
5 / 50
The changes in the reflectivity/emissivity with time, is called ?
6 / 50
In time-cost optimization of a project, crashing is done____________?
7 / 50
Cavitation will begin when_____________?
8 / 50
The bulk modulus of elasticity _________?
9 / 50
Pick up the correct statement from the following?
10 / 50
Composting and lagooning are the methods of______?
11 / 50
88 is 1400 kg/cm2 and bond stress is 6 kg/cm2, the If tensile stress of a steel rod of diameter required bond length of the rod is___________?
12 / 50
Hydraulic lime is obtained by______?
13 / 50
The meander pattern of a river is developed by________?
14 / 50
Maximum number of vehicles can be parked with______?
15 / 50
A nuisance is experienced in diluting water if dilution factor is less than________?
16 / 50
Normally, the angle of roof truss with asbestos sheets should not be less than______?
17 / 50
The pole distance is measured in__________?
18 / 50
The diagram which shows the approximate path of vehicles and pedestrians involved in accidents is known as__________?
19 / 50
If the elevation of hydraulic grade line at the junction of three pipes is above the elevation of reservoirs B and C and below reservoir A, then the direction of flow will be__________?
20 / 50
The phenolic compounds in public water supply should not be more than______?
21 / 50
The maximum depth of sedimentation tanks is limited to_______?
22 / 50
If A is the amplitude of particle executing simple harmonic motion, then the total energy E of the particle is__________?
23 / 50
Imhoff cone is used to determine____________?
24 / 50
The spacing of transverse reinforcement of column is decided by the following consideration______?
25 / 50
The angle of internal friction of soil mass is the angle whose______?
26 / 50
The specific weight of water is 1000 kg/m? ______?
27 / 50
What is the ordinary interest on P1,500.50 for 182 days at 5.2% ?
28 / 50
The main constituent which imparts hydraulicity to hydraulic lime is_____?
29 / 50
Which of the following has high tensile strength ?
30 / 50
The flow in which the velocity vector is identical in magnitude and direction at every point, for any given instant, is known as__________?
31 / 50
Design of R.C. cantilever beams, is based on the resultant force at_____?
32 / 50
A liquid would wet the solid, if adhesion forces as compared to cohesion forces are________?
33 / 50
The ratio of the area of cross-section of a circular section to the area of its core, is______?
34 / 50
The normal altitude of GPS satellite is about_______?
35 / 50
Which of the following is indicated by a warning sign ?
36 / 50
The sewer pipes_________?
37 / 50
The area is measured correct to the nearest__________?
38 / 50
If B is the width of formation, d is the height of the embankment, side slope S : 1, for a highway with no transverse slope, the area of cross-section is__________?
39 / 50
The ratio of circumferential stress to the longitudinal stress in the walls of a cylindrical shell, due to flowing liquid, is_________?
40 / 50
Bishop?s method of stability analysis______?
41 / 50
Which of the following is not a component of the shield ?
42 / 50
43 / 50
If the expected time of completion of a project is 60 weeks with a standard deviation of 5 weeks, the probability of completing the project in 50 weeks and 65 weeks respectively will be_________?
44 / 50
Due to shrinkage stresses, a simply supported beam having reinforcement only at bottom tends to_____________?
45 / 50
The degree of indeterminacy of the frame in the given figure, is_________?
46 / 50
The maximum diameter of a bar used in a ribbed slab, is_____?
47 / 50
In the truss shown in given figure, the force in member BD is_____?
48 / 50
By over-reinforcing a beam, the moment of resistance can be increased not more than_______?
49 / 50
Generally the purlins are placed at the panel points so as to avoid_________?
50 / 50
What is the present worth of a P500 annuity starting at the end of the third year and continuing to the end of the fourth year, if the annual interest rate is 10 % ?
Provide Your Information
Your score is
The average score is 0%
Restart quiz
