Civil Engineering Quiz 34
1 / 50
If the loading on a pre-stressed rectangular beam, is uniformly distributed, the tendon to be provided should be______?
2 / 50
Pick up the important characteristic of a target which facilitates its identification from the following ?
3 / 50
An open cubical tank of 2 m side is filled with water. If the tank is rotated with an acceleration such that half of the water spills out, then the acceleration is equal to______?
4 / 50
The following sights are taken on a ?turning point?_______?
5 / 50
Coefficient of compressibility is______?
6 / 50
The property of a fluid which enables it to resist tensile stress is known as_______?
7 / 50
Removal of oil and grease from sewage, is known___________?
8 / 50
According to the Snell?s law if an electromagnetic wave is incident in a medium (refractive index n1) on another medium (refractive index m2)_______?
9 / 50
For a single point load W moving on a symmetrical three hinged parabolic arch of span L, the maximum sagging moment occurs at a distance x from ends. The value of x is_________?
10 / 50
Strength of concrete increases with_______?
11 / 50
During the opening of a valve in a pipe line, the flow is__________?
12 / 50
The horizontal component of force on a curved surface is equal to the______?
13 / 50
For non-scouring velocity 5 m/sec, the type of sewers generally preferred to, is___________?
14 / 50
Pick up the correct statement from the following ?
15 / 50
As per ICAO recommendation, the rate of change of longitudinal gradient per 30 m length of vertical curve for A and B type of airports is limited to a maximum of_________?
16 / 50
In highway construction, rolling starts from_______?
17 / 50
The most efficient traffic signal system is_______?
18 / 50
The part radiation due to scattered/diffused radiation entering the field of view of a remote sensor other than that from the required target________?
19 / 50
Uniformity coefficient of a soil is_________?
20 / 50
Number of switches provided on a Gaunt-letted track is______?
21 / 50
carrying a uniformly distributed load per metre length is suspended at the A pile of length centre and from other two points 0.15 L from either end ; the maximum hogging moment will be______?
22 / 50
Which of the following can be used as a meter fall ?
23 / 50
The total energy of each particle at various places in the case of perfect incompres sible fluid flowing in continuous sream_______?
24 / 50
The maximum permissible span of asbestos cement sheets is_____________?
25 / 50
The ratio of maximum shear stress to average shear stress of a circular beam, is_______?
26 / 50
Which one of the following parameters is accurate for DGPS ?
27 / 50
A 200 mm thick wall made of modular bricks is 5 m long between cross walls and 3.8 m clear height between RCC slabs at top and bottom. The slenderness ratio of the wall is_______?
28 / 50
The independent float affects only______?
29 / 50
Transit rule of adjusting the consecutive coordinates of a traverse is used where_______?
30 / 50
How many commandments are given in PEC Code of Ethics?
31 / 50
The maximum permissible size of aggregates to be used in casting the ribs of a slab, is_____?
32 / 50
Which of the following do not have identical dimensions ?
33 / 50
Before discharging the foul sewage into rivers, it is generally treated by____________?
34 / 50
If the natural water content of soil mass lies between its liquid limit and plastic limit, the soil mass is said to be in_____?
35 / 50
The non-clog pump which permits solid matter to pass out with the liquid sewage, is_______?
36 / 50
What is the term for an annuity with a fixed time span ?
37 / 50
The slope of isochrone at any point at a given time indicates the rate of change of______?
38 / 50
Select the correct statement_______?
39 / 50
The stream which does not have any base flow contribution is called_______?
40 / 50
What do you call the after-tax present worth of all depreciation effects over the depreciation period of the asset ?
41 / 50
Excess of alumina in brick earth makes the brick_____?
42 / 50
The number of treads in a flight is equal to______?
43 / 50
The angle which an inclined plane makes with the horizontal when a body placed on it is about to move down is known as angle of_________?
44 / 50
Dynamic viscosity of most of the liquids with rise in temperature___________?
45 / 50
A singly reinforced concrete beam of 25 cm width and 70 cm effective depth is provided with 18.75 cm2 steel. If the modular ratio (m) is 15, the depth of the neutral axis, is________?
46 / 50
A type of bond to which are attached coupons indicating the interest due and the date when such interest is to be paid is called ___________?
47 / 50
The load on each axle of a locomotive is 22 tonnes. If the coefficient of friction is 0.2, then the hauling capacity due to 3 pairs of driving wheels will be_______?
48 / 50
The permissible bending stresses Pbet for steel slab bases should not exceed______?
49 / 50
In a sedimentation tank (length L, width B, depth D) the settling velocity of a particle for a discharge Q, is___________?
50 / 50
In PERT analysis, the time estimates of activities and probability of their occurrence follow______?
Provide Your Information
Your score is
The average score is 0%
Restart quiz
