Civil Engineering Quiz 44

0%
0

Civil Engineering Quiz 44

1 / 50

The horizontal deflection of a parabolic curved beam of span 10 m and rise 3 m when loaded with a uniformly distributed load l t per horizontal length is (where Ic is the M.I. at the crown, which varies as the slope of the arch)__________?

2 / 50

In what method of computing depreciation where it assumes that the annual cost of depreciation is a fixed percentage of the book value at the beginning of the year ?

3 / 50

For interpolation of satellite data used for monitoring dynamic changes that occurs on the earth surface, the most suitable orbit for the satellite is_____?

4 / 50

As the percentage of steel increases_______?

5 / 50

Which one of the following is considered to be an advantage of the heading and benching method of tunnel construction?

6 / 50

The angle of projection at which the horizontal range and maximum height of a projectile are equal to____________?

7 / 50

Which of the following methods is more suitable for the determination of permeability of clayey soil ?

8 / 50

The percentage of alumina in a good brick earth lies between_______?

9 / 50

An open tank contains 1 m deep water with 50 cm depth of oil of specific gravity 0.8 above it. The intensity of pressure at the bottom of tank will be_______?

10 / 50

Direct measurement of permeability of the specimen at any stage of loading can be made______?

11 / 50

A body moves, from rest with a constant acceleration of 5 m per sec The distance covered in 5 sec is most nearly_______?

12 / 50

The allowable tensile stress in mild steel stirrups, reinforced cement concrete, is______?

13 / 50

The drain which is provided parallel to roadway to intercept and divert the water from hill slopes is known as______?

14 / 50

Select the correct statement?

15 / 50

P = / L? is the equation for Euler?s crippling load if________?

16 / 50

For determining the support reactions at A and B of a three hinged arch, points B and Care joined and produced to intersect the load line at D and a line parallel to the load line through A at D?. Distances AD, DD? and AD? when measured were 4 cm, 3 cm and 5 cm respectively. The angle between the reactions at A and B is__________?

17 / 50

When drainage to sewage ratio is 20, the peak dry weather flow is______?

18 / 50

For a number of columns constructed in a rcjw, the type of foundation provided, is______?

19 / 50

In areas where light rains are uniformly distributed throughout the year, the type of sewerage system to be adopted is______?

20 / 50

A series of closely spaced contour lines represents a__________?

21 / 50

The cross hairs in the surveying telescope are placed_____________?

22 / 50

When the velocity distribution is uniform over the cross-section, the correction factor for momentum is_________?

23 / 50

If the focal length of the object glass is 25 cm and the distance from object glass to the trunnion axis is 15 cm, the additive constant is______?

24 / 50

?th or ?th extra space is left in sewer pipes at maximum discharge for________?

25 / 50

In the construction of arches, sand box method is used for_______?

26 / 50

Agate cap is fitted with a________?

27 / 50

The C.G. of a right circular solid cone of height h lies at the following distance from the base_____________?

28 / 50

A current meter is used to measure the_________?

29 / 50

The load carrying capacity of a helically reinforced column as compared to that of a tied column is about_______?

30 / 50

The reduction in project time normally results in______?

31 / 50

The settlement velocity of a solid (diameter 0.5 mm, specific gravity 1.75) in water having temperature 10?C, is_____________?

32 / 50

The method of design of flexible pavement as recommended by IRC is____________?

33 / 50

Pick up the correct statement from the following?

34 / 50

In the equation of virtual work, following force is neglected______?

35 / 50

Minimum pull in a suspended cable with supports at two ends is equal to___________?

36 / 50

Williot-Mohr diagram is used to determine deflection in_________?

37 / 50

A floating body is said to be in a state of stable equilibrium________?

38 / 50

In the activated sludge process_________?

39 / 50

Least force required to draw a body up the inclined plane is W sin (plane inclination + friction angle) applied in the direction_________?

40 / 50

Discrete or granular particles change their________ ?

41 / 50

Uniform flow occurs when___________?

42 / 50

Total strain energy theory for the failure of a material at elastic limit, is known________?

43 / 50

The pitch of the main bars in a simply supported slab, should not exceed its effective depth by_____________?

44 / 50

Which of the following errors can be neutralised by setting the level midway between the two stations ?

45 / 50

The time of concentration is defined as______?

46 / 50

Choose the correct relationship________?

47 / 50

Ay between two stream lines represents_______?

48 / 50

For an annual flood series arranged in descending order of magnitude, the return for a magnitude listed at position period m in a total data N is_______?

49 / 50

Which one of the following resists hydrogen sulphide corrosion ?

50 / 50

cross sections of bronze and copper bars of equal lengt b c are their Ab and Ac are the respective stresses due to load P. If Pb and Pc are the loads shared by them, (where Eb and Ec are their modulii)___________?

Provide Your Information

Your score is

The average score is 0%

0%

Qunoot e Nazilah
Dua e Hajat
4 Qul
6 Kalma
Dua-e-Akasha
Darood Akbar
Surah Fatiha
Dua-e-Ganj Ul Arsh
Dua-e-Jamilah
Ayat-ul-Kursi