Electrical Engineering Quiz 2
1 / 50
Thevenin resistance Rth is found
2 / 50
The good power factor of an induction motor can be achieved if the average flux density in the air gap is___________?
3 / 50
In a 3-phase, 4-pole, 50 Hz synchronous motor, the frequency, pole number and load torque all are halved. The motor speed will be____________?
4 / 50
In a radio receiver, we generally use ????.. oscillator as a local oscillator
5 / 50
Silicon controlled rectifier can be turned on____________?
6 / 50
The working of a synchronous motor is similar to_____________?
7 / 50
_____________is viscoelastic?
8 / 50
The common-mode gain is ________________?
9 / 50
When an input signal 1 is applied to a NOT gate, the output is ______________?
10 / 50
The process of heat transfer during the reentry of satellites and missiles, at very high speeds, into earth?s atmosphere is known as_______________?
11 / 50
The transformer ratings are usually expressed in terms of______________?
12 / 50
The magnetising current of a transformer is usually small because it has___________?
13 / 50
A power supply which has voltage regulation of ____________ is unregulated power supply?
14 / 50
A cumulatively compounded long shunt generator when operating as a motor would be____________?
15 / 50
Two similar 15 V Zeners are connected in series. What is the regulated output voltage ?
16 / 50
During the charging of a lead-acid cell__________?
17 / 50
In case of a double cage induction motor, the inner cage has__________?
18 / 50
For high efficiency of transfer of power, internal resistance of the source should be____________?
19 / 50
A dynamo converts______________?
20 / 50
In a capacitor, the electric charge is stored in_________?
21 / 50
Series reactors should have________________?
22 / 50
Over modulation results in ______________?
23 / 50
MOSFET stands for______________?
24 / 50
In a synchronous motor, damper windings are provided on____________?
25 / 50
Which of the following is exhibited by Root locus diagrams ?
26 / 50
The terminal voltage of a D.C. shunt generator drops on load because of all of the following reasons except:_____________?
27 / 50
The only function of NOT gate is to__________________?
28 / 50
A Triac has three terminals viz ___________?
29 / 50
The capacitance of reversed bised junction J2 in a thyristor is CJ2 = 20 pF and can be assumed to be independant of the off state voltage. The limiting value of the charging current to turn on the thyristor is 16 m What is the critical value of dv/dt?
30 / 50
Which of the following uses electric energy and does not convert it into any other form ?
31 / 50
A Wien bridge oscillator uses___________feedback?
32 / 50
When the initial conditions of a system are specified to be zero it implies that the system is________________?
33 / 50
To protect most of the electrical equipment handling low power, the types of relays used are______________?
34 / 50
In a npn transistor,_____________are the minority carriers?
35 / 50
In the d.c. equivalent circuit of a transistor amplifier, the capacitors are considered__________________?
36 / 50
The motor used for the compressors is____________?
37 / 50
The efficiency of a modern boiler using coal and heat recovery equipment is about_____________?
38 / 50
The torque of an induction motor is___________?
39 / 50
The forward voltage drop across a silicon diode is about _______________?
40 / 50
If the firing angle becomes negative, then the rectifier begins to work as_______________?
41 / 50
The effect of considering friction in steam nozzles for the same pressure ratio leads to_________?
42 / 50
In a TRF radio receiver, the RF and detection stages are tuned to______________?
43 / 50
The value of the capacitance depends upon the________________?
44 / 50
The ability of charged bodies to exert force on 6ne another is attributed to the existence of____________?
45 / 50
In repulsion motor, maximum torque is developed when____________?
46 / 50
The usual values of maximum flux densities for distribution transformers using hot rolled silicon steel are______________?
47 / 50
Edward?s air pump____________?
48 / 50
_____________is the reference input minus the primary feedback?
49 / 50
The magneto-motive force is______________?
50 / 50
If the value of a is 0.9, then value of ? is___________?
Provide Your Information
Your score is
The average score is 94%
Restart quiz