Electrical Engineering Quiz 36
1 / 50
In a split phase motor, the running winding should have?
2 / 50
A second condition for oscillations is____________?
3 / 50
In a surface condenser if air is removed, there is___________?
4 / 50
Main traction systems used in India are, those using______________?
5 / 50
In a series?parallel circuit, individual component power dissipation are calculated using_____________?
6 / 50
For the same a.c. power output as above, what should be the minimum power rating of transistor for class B operation?
7 / 50
A feedback circuit usually employs _________________ network?
8 / 50
When a live conductor of public electric supply breaks down and touches the earth which of the following will happen?
9 / 50
The main objective of static power converters is to____________?
10 / 50
A certain Wheatstone bridge has the following resistor values: R1 = 10 k?, R2 = 720 ?, and R4 = 2.4 k?. The unknown resistance is_____________?
11 / 50
Less maintenance troubles are experienced in case of___________?
12 / 50
The rotor of a hysteresis motor is made of___________?
13 / 50
On which of the following factors does the sensitivity of a closed loop system to gain changes and load disturbances depend ?
14 / 50
Secondary air is the air used to______________?
15 / 50
____________is a fixed frequency oscillator?
16 / 50
Which of the following is not a method for estimating depreciation charges?
17 / 50
In closed loop control system, with positive value of feedback gain the overall gain of the system will______________?
18 / 50
During the charging and discharging of a nickel-iron cell____________?
19 / 50
Any externally introduced signal affecting the controlled output is called a______________?
20 / 50
Which of the following statement is true________________?
21 / 50
In series resonance, there is__________________?
22 / 50
A mica capacitor and a ceramic capacitor both have the same physical dimensions. Which will have more value of capacitance _______?
23 / 50
Static error coefficients are used as a measure of the effectiveness of closed loop systems for specified ___________ input signal?
24 / 50
The number of slip rings on a squirrel cage induction motor is usually____________?
25 / 50
Which type of bearing is provided in small induction motors to support the rotor shaft ?
26 / 50
In a pure inductive circuit if the supply frequency is reduced to 1/2, the current will__________?
27 / 50
A relay is superior to a mechanical switch because it _______________?
28 / 50
Superconductivity is observed for____________?
29 / 50
When the dielectric is homogeneous,the potential gradient is_____________?
30 / 50
Poor power factor________?
31 / 50
Flashing the field of D.C. generator means:______________?
32 / 50
Surface resistance of an insulating material is reduced due to the______________?
33 / 50
The torque developed in the cage induction motor with autostarter is___________?
34 / 50
Which of the following motors has series characteristics ?
35 / 50
In which single-phase motor, the rotor has no teeth or winding ?
36 / 50
When the temperature changes, the operating point is shifted due to _______________?
37 / 50
Specific energy consumption becomes________________?
38 / 50
For a buck converter to reduce the conduction losses in diode
39 / 50
Which of the following D.C. generators will be in a position to build up without any residual magnetism in the poles?
40 / 50
Which of the following statement about D.C. generators is false ?
41 / 50
Locked rotor current of a shaded pole motor is____________?
42 / 50
The output stage of a multistage amplifier usually employs______________?
43 / 50
Magnetic moment is a_____________?
44 / 50
In jet type condensers___________?
45 / 50
The current flow through electrolyte is due to the movement of____________?
46 / 50
Those substances of the cell which take active part in chemical combination and hence produce electricity during charging or discharging are known as________materials
47 / 50
An SCR is made of silicon and not germanium because silicon _________________?
48 / 50
In a superconductor the value of critical density depends upon______________?
49 / 50
The function of snubber circuit connected across the SCR is to___________?
50 / 50
In a phase shift oscillator, we use____________RC sections?
Provide Your Information
Your score is
The average score is 93%
Restart quiz
