Electrical Engineering Quiz 4
1 / 50
Zener diode can be used as__________________?
2 / 50
In the transformer following winding has got more cross-sectional area______________?
3 / 50
A load curve indicates___________?
4 / 50
Machines cooled by direct cooling method may be called_____________?
5 / 50
The most commonly used transistor arrangement is____________arrangement?
6 / 50
A reverse bias pn junction has_____________?
7 / 50
The direction of rotation of a D.C. series motor can be changed by___________?
8 / 50
In an Anderson bridge, the unknown inductance is measured in terms of_______________?
9 / 50
A 1,000 V power supply would use_____________ as a filter capacitor?
10 / 50
Empire tape is__________?
11 / 50
The density of hydrogen is __________ times the density of air?
12 / 50
In heating the ferromagnetic material by induction heating, heat is produced due to_____________?
13 / 50
Which of the following devices are commonly used as error detectors in instruments ?
14 / 50
Resistance grounding is used for voltage between_________________?
15 / 50
Electrolyte used in a lead-acid cell is__________?
16 / 50
A synchronous motor can operate at____________?
17 / 50
A JFET has three terminals, namely________________?
18 / 50
Hysteresis is desirable in Schmitt-trigger, because______________?
19 / 50
Magnetic circuit breaker has ___________ trip action
20 / 50
Which of the following materials is not used for transmission and distribution of electrical power________________?
21 / 50
Transformer breaths in when_______________?
22 / 50
If an inductance is connected in one arm of bridge and resistances in the remaining three arms____________?
23 / 50
Salvage value of the plant is always____________?
24 / 50
The efficiency of the copper oxide rectifier seldom exceeds____________?
25 / 50
At a certain frequency, the output voltage of a filter is 6 V and the input is 12 V. The voltage ratio in decibels is_____________?
26 / 50
_________________cannot be fabricated on an IC?
27 / 50
For measurement of mutual inductance we can use________________?
28 / 50
Transmission voltage of 11 kV is normally used for distances up to_____km?
29 / 50
An important limitation of a crystal oscillator is____________?
30 / 50
The speed of a synchronous motor:
31 / 50
Short circuit test on transformers is conducted to determine____________?
32 / 50
The square wave operation of 3 phase VSI lines contains the harmonics. The amplitudes are____________?
33 / 50
A thyristor can termed as__________?
34 / 50
The purpose of emitter capacitor (i.e. capacitor across RE) is to ______________?
35 / 50
The total resistance of a parallel circuit is 50 ?. If the total current is 120 mA, the current through the 270 ? that makes up part of the parallel circuit is approximately_______________?
36 / 50
With zero volts on both inputs, an OP-amp ideally should have an output _______________?
37 / 50
The value of exciting or magnetizing current depends upon which of the following factors ?
38 / 50
When 4 volts e.m.f. is applied across a 1 farad capacitor, it will store energy of_____________?
39 / 50
Which of the following is measured by using a vector voltmeter ?
40 / 50
In ac ? dc conversion, when the switch is closed then the sum of voltages around the loop is____________?
41 / 50
A linear resistor having 0 < R < ?o is a______________?
42 / 50
The operation of a D.C. machine with large air gap lengths is comparatively_____________?
43 / 50
In which of the following applications the load on motor changes in cyclic order ?
44 / 50
Kirchhoffs current law is applicable to only
45 / 50
In a mercury arc rectifier positive ions are attracted towards______________?
46 / 50
In a domestic cake baking oven the temperature is controlled by________________?
47 / 50
Fleming?s left hand rule is used to find_________________?
48 / 50
A __________ device prevents the oscillation of the moving system and enables the latter to reach its final position quickly___________?
49 / 50
Pressure error can be measured by which of the following ?
50 / 50
For large power transformers, self oil cooled type or air blast type which of the following values of current density may be used?
Provide Your Information
Your score is
The average score is 94%
Restart quiz
