Electrical Engineering Quiz 44
1 / 50
For the parallel operation of two or more D.C. compound generators, we should ensure that_______________?
2 / 50
When the transistor (CE arrangement) is in the cut off region, the collector current is ______________?
3 / 50
Demodulation is done in ________________?
4 / 50
The path of a magnetic flux in a transformer should have______________?
5 / 50
The closed-loop voltage gain of an inverting amplifier equal to______________?
6 / 50
Which of the following is a ferromagnetic material ?
7 / 50
An RL low-pass filter consists of a 5.6 mH coil and a 3.3 k? resistor. The output voltage is taken across the resistor. The circuit?s critical frequency is______________?
8 / 50
A dynamometer wattmeter can be used for______________?
9 / 50
In an automatic control system which of the following elements is not used ?
10 / 50
Long distance transmission is easy for________________?
11 / 50
Magnetic compass needle will be deflecting if it is kept near________________?
12 / 50
An induction motor has relatively high power factor at__________?
13 / 50
Direct conversion of heat into electric power is possible through__________?
14 / 50
In an unregulated power supply, if input a.c. voltage increases, the output voltage _______________?
15 / 50
Heat is transferred simultaneously by condition, convection and radiation_____________?
16 / 50
If the negative potential on the control grid of CRT is increased, the intensity of spot _____________?
17 / 50
Regenerative feedback implies feedback with_______________?
18 / 50
The frequency and time domain are related through which of the following ?
19 / 50
Voltage applied across a ceramic dielectric produces an electrolytic field 100 times greater than air. What will be the value of dielectric constant ________?
20 / 50
The ideal load factor should be_____________?
21 / 50
Which of the followings is/are active element?
22 / 50
The force per unit charge is know as__________________?
23 / 50
A car is raining at a constant speed of 50 km/h, which of the following is the feedback element for the driver ?
24 / 50
The current drawn by the armature of D.C. motor is directly proportional to__________?
25 / 50
The changes in volume of transformer cooling oil due to variation of atmospheric temperature during day and night is taken care of by which part of transformer?
26 / 50
A monostable vibrator has_____________
27 / 50
Calculate the cutoff frequency of a first-order low-pass filter for R1 = 2.5k? and C1 = 0.05?F___________?
28 / 50
If variable part of annual cost on account of interest and depreciation on the capital outlay is equal to the annual cost of electrical energy wasted in the conductors, the total annual cost will be minimum and the corresponding size of conductor will be most economical. This statement is known as___________________?
29 / 50
In an AM wave useful power is carrier by ______________?
30 / 50
Spark plug makes use of which of the following materials for insulation ?
31 / 50
A Zener diode______________?
32 / 50
The switch board instruments________________?
33 / 50
Minimum voltage regulation occurs when the power factor of the load is_____________?
34 / 50
The base resistor method is generally used in ________________?
35 / 50
A pure capacitor connected across an A.C. voltage consumed 50 W. This is due to________?
36 / 50
The total deficiency or excess of electrons in a body is known as____________?
37 / 50
If gate current is increased, then anode-cathode voltage at which SCR closes_________________?
38 / 50
When drain voltage equals the pinch-off-voltage, then drain current ___________ with the increase in drain voltage?
39 / 50
In the differential voltage gain & the common mode voltage gain of a differential amplifier are 48db &2db respectively, then its common mode rejection ratio is__________?
40 / 50
In a series L-C circuit at the resonant frequency the__________?
41 / 50
Emitter follower is used for ________________?
42 / 50
Gate circuit or triggering circuit of a thyristor is
43 / 50
The effective channel length of a MOSFET in a saturation decreases with increase in___________?
44 / 50
The magnitude of the induced e.m.f. in a conductor depends on the______________?
45 / 50
Which of the following materials is used for making coils of standard resistances ?
46 / 50
If a third equal and similar charge is placed between two equal and similar charges, then this third charge will_____________?
47 / 50
The output transformer used in a power amplifier is a _____________ transformer?
48 / 50
If a single phase induction motor runs slower than normal, the most likely defect is_____________?
49 / 50
In the double tuned circuit, if the mutual inductance between the two tuned circuits is decreased, the level of resonance curve ___________________?
50 / 50
The push-pull circuit must use ______________ operation?
Provide Your Information
Your score is
The average score is 92%
Restart quiz
