Electrical Engineering Quiz 53
1 / 50
A no-load test is performed on a transformer to determine_______________?
2 / 50
The property of a conductor due to which it passes current is called___________?
3 / 50
Under over voltage condition impedance offered by the voltage clamping device is__________?
4 / 50
The number of armature parallel paths in a two-pole D.C. generator having duplex lap winding is______________?
5 / 50
The superposition theorem requires as many circuits to be solved as there are____________?
6 / 50
If a square wave is fed to a differentiating circuit, the output will be _____________?
7 / 50
The selection of an electric motor for any application depends on which of the following factors ?
8 / 50
In a capacitor start single-phase motor, when capacitor is replaced by a resistance____________?
9 / 50
When the crystal current diode current is large, the bias is ______________?
10 / 50
In a lead-acid battery the energy is stored in the form of___________?
11 / 50
Hysteresis loss least depends on____________?
12 / 50
is the property of absorbing moisture from atmosphere_____________?
13 / 50
Which of the following are not repayable after a stipulated period?
14 / 50
At transition temperature the value of critical field is____________?
15 / 50
Zero initial condition for a system means_______________?
16 / 50
Which of the following has the highest value of thermal conductivity ?
17 / 50
In a certain common-source D-MOSFET amplifier, Vds =3.2 V r.m. and Vgs = 280 mV r.m.s. The voltage gain is_______________?
18 / 50
Negative feedback in an amplifier____________?
19 / 50
The square waveform of current has following relation between r.m.s. value and average value?
20 / 50
Heat control switches are used in__________________?
21 / 50
Electric pressure is also called________?
22 / 50
capacitors can be used only for D.C ?
23 / 50
Which of the following statements regarding hysteresis motor is in incorrect?
24 / 50
When the load is above _______________ a synchronous motor is found to be more economical?
25 / 50
What is/are the configurable functions of each and every IOBs connected around the FPGA device from the operational point of view ?
26 / 50
In D.C. machines the number of slots per pole usually lies___________?
27 / 50
A 741-Type OP-AMP has a gain-bandwith product of 1MHz. A non-inverting amplifier using this opamp & having a voltage gain of 20db will exhibit -3db bandwidth of______________?
28 / 50
The material commonly used for sheaths of underground cables is______________?
29 / 50
____________are used for construction of core of electromagnets?
30 / 50
When a 1.6 k? resistor and a 120? resistor are connected in parallel, the total resistance is____________?
31 / 50
The point of intersection of d.c. and a.c. load lines represents __________________?
32 / 50
A small coil lies inside a large coil. The two coils are horizontal concentric and carry currents in opposite directions. The large coil will experience______________?
33 / 50
A zener diode is________________ device?
34 / 50
When two ends of a circular uniform wire are joined to the terminals of a battery, the field at the center of the circle?
35 / 50
A star circuit has element of resistance R/2. The equivalent delta elements will be_____________?
36 / 50
Resistances can be measured with the help of_______________?
37 / 50
For starting a D.C. motor a starter is required because___________?
38 / 50
Which of the following motors is preferred for tape-recorders ?
39 / 50
Thermal voltage VT can be given by____________?
40 / 50
Which of the following cell has a. reversible chemical reaction ___________?
41 / 50
A nuclear power plant is invariably used as a__________?
42 / 50
SF6 gas______________?
43 / 50
A synchronous motor develops maximum power when load angle is____________?
44 / 50
Electric force between two point charges in air or vacuum is F. If we replace air or vacuum by an insulator (dielectric) of relative permitivity Cr the force between the charges will_______________?
45 / 50
Evaporative type of condenser has___________?
46 / 50
Insulating materials have the function of______________?
47 / 50
The function of conservator in a transformer is___________________?
48 / 50
If firing angle in an SCR circuit is increased, the output _____________?
49 / 50
The disadvantage of base resistor method of transistor biasing is that it_________________?
50 / 50
In a full wave rectifier, the rectification ratio is approximately equal to____________?
Provide Your Information
Your score is
The average score is 97%
Restart quiz
